Witam.
mam linuxa opensuse 10.2, karte sieciowa dlink dwlg520 i zainstalowane sterowniki madwifi ( pakiet rpm z madwifi.org dla v.10.2). Poustawiałem adresy ( ip, mac etc.), mam polaczenie ale niemam neta ;/
LOGI:
Has�o:
linux:/home/linux # ifconfig ath0 down
linux:/home/linux # ifconfig ath0 hw ether adres_MAC
linux:/home/linux # ifconfig ath0 adres_ip
linux:/home/linux # ifconfig ath0 up
linux:/home/linux # iwconfig ath0 essid "ap"
linux:/home/linux # iwconfig ath0 ap 00:4f:62:0f:98:b6
linux:/home/linux # route add default gw adres_bramy
linux:/home/linux #
linux:/home/linux # iwconfig ath0
ath0 IEEE 802.11g ESSID:"ap" Nickname:"linux"
Mode:Managed Frequency:2.457 GHz Access Point: 00:4F:62:0F:98:B6
Bit Rate:1 Mb/s Tx-Power:18 dBm Sensitivity=1/1
Retry:off RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=20/70 Signal level=-75 dBm Noise level=-95 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
linux:/home/linux # netstat -nr
Kernel IP routing table
Destination Gateway Genmask Flags MSS Window irtt Iface
10.100.3.0 0.0.0.0 255.255.255.0 U 0 0 0 ath0
127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo
0.0.0.0 10.100.3.1 0.0.0.0 UG 0 0 0 ath0
linux@linux:~> su
Has�o:
linux:/home/linux # iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
wifi0 no wireless extensions.
ath0 IEEE 802.11g ESSID:"ap" Nickname:"linux"
Mode:Managed Frequency:2.462 GHz Access Point: 00:4F:62:0F:98:B6
Bit Rate:1 Mb/s Tx-Power:18 dBm Sensitivity=1/1
Retry:off RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=17/70 Signal level=-78 dBm Noise level=-95 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
sit0 no wireless extensions.
linux:/home/linux # ifconfig
ath0 Link encap:Ethernet HWaddr adres_mac
inet addr:adres_ip Bcast:10.100.3.255 Mask:255.255.255.0
inet6 addr: fe80::20e:2eff:fea3:f255/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
eth0 Link encap:Ethernet HWaddr 00:11:D8:BD:B2:42
UP BROADCAST NOTRAILERS MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Interrupt:177
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:236 errors:0 dropped:0 overruns:0 frame:0
TX packets:236 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:17416 (17.0 Kb) TX bytes:17416 (17.0 Kb)
wifi0 Link encap:UNSPEC HWaddr 00-19-5B-CD-13-8C-00-00-00-00-00-00-00-00-00-00
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:3991 errors:0 dropped:0 overruns:0 frame:9902
TX packets:1995 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:199
RX bytes:305948 (298.7 Kb) TX bytes:110114 (107.5 Kb)
Interrupt:58
Podobno jest to wina braku bramy domsylnej, ale ustawiam ja poleceniem"
route add default gw adres_bramy
Moze wie ktos jak to naprawic, dlaczego tak sie dzieje?
Pozdrawiam
